Standing at DRIVER’S Door,Check Operation of Equipment:
3-15 Driver’s seat headrest
Door lock and key:
3-16 Power: Verify all doors lock/unlock
3-17 Manual: Verify driver door locks/unlocks
3-18 Check keyless entry
Note: Leave key in “On” position for the following checks.
Seated in REAR Seat (Driver’s Side), Check Operation of Equipment:
3-19 Seat belt
Window regulators/motors:
3-20 Power: Verify switch operation, including master
switch lock-out
3-21 Manual: Verify window regulator operation
3-22 Door lock
3-23 Child security lock
3-24 Interior light: Light goes on/off when door is
opened/closed
3-25 Tightness of child seat anchors (if installed)
Standing Outside Car at REAR Door (Driver’s Side), Check Operation of Equipment:
3-26 Rear seat back latches
3-27 Fuel filler door
Rear Compartment:
3-28 Cargo light functions
3-29 Spare tire present, in good condition, and properly
inflated
3-30 Jack and lug wrench present and in good condition
3-31 Jack and spare tire retainer/cover hardware present
3-32 No water/fluid damage
3-33 Tightness of child seat anchors (if installed)
3-34 Rear defogger operation (Feel backlight to verify grid
is warm)
Seated in REAR Seat (Passenger Side), Check Operation of Equipment:
3-35 Seat belt
Window regulators/motors:
3-36 Power: Verify switch operation
3-37 Manual: Verify window regulator operation
3-38 Door lock
3-39 Child security lock
3-40 Interior light: Light goes on/off when door is
opened/closed
3-41 Tightness of child seat anchors (if installed)
Standing at FRONT PASSENGER Door, Check Operation of Equipment:
3-42 Front passenger seat headrest
Door lock and key:
3-43 Verify door locks/unlocks
Seated in FRONT PASSENGER Seat, Check Operation of Equipment:
3-44 Seat adjustment (if applicable: power switches, lumbar
adjustment, heater switches)
3-45 Front passenger’s seat belt
3-46 Window regulator (manual windows only)
3-47 Outside mirror control (manual control)
3-48 Door lock
3-49 Interior light: Light goes on/off when door is
opened/closed
3-50 Passenger air bag (Inspect exterior surface)
3-51 Glove box door open/closes and is properly aligned
3-52 Turn off rear defogger and ignition switch at this
point
Service Stall Inspection and Testing
Using ARBST Tester, Verify Condition of the Following:
4-1 Battery (Voltage, specific gravity)
4-2 Starting system
4-3 Charging system
Turn Off All Noise-Producing Accessories, Then Start the Engine and Let it Idle:
4-4 No abnormal engine noise or vibrations
4-5 No abnormal smoke from exhaust pipe
4-6 No exhaust leaks/noise
With the Engine Off, Perform These Checks:
4-7 Air filter condition
4-8 No visible wear or damage on belt, hoses, clamps,
seals, and gaskets
4-9 No engine oil, coolant, or transaxle fluid leaks evident
4-10 No coolant recovery reservoir leaks
4-11 Drive belt/tensioner check
4-12 Engine mounts not collapsed
4-13 Perform HVAC preliminary checks
Raise the Vehicle on a Hoist and Perform These Checks:
Inspect for leaks:
4-14 Engine oil
4-15 Coolant
4-16 Transmission fluid
4-17 Transfer case fluid (if applicable)
4-18 Differential fluid level
4-19 No fuel system leaks
4-20 Drive axle and steering rack boots are not torn or
loose
4-21 Vehicle has not been lowered or raised with
non-OEM components
4-22 Steering or suspension components are not loose
4-23 No leaking struts/shocks
4-24 Exhaust system components and hangers are not
leaking or loose
4-25 No visible road hazard damage
4-26 Wheel bearings are in proper working order
Remove All Four Wheels, Inspect and Measure Brake Components:
All brake pad and shoe linings have at least 50% of their useful life remaining:
4-27 Left Front
4-28 Right Front
4-29 Right Rear
4-30 Left Rear
4-31 No severe scoring or corrosion on rotors or drums
4-32 No leaking or damaged calipers, caliper pin seals,
wheel cylinders, lines, or hoses
4-33 All calipers and pads move freely
4-34 No damaged parking brake assemblies, cables, or
attaching hardware
Tires:
4-35 Tire sidewall condition
4-36 Tire tread wear patterns
4-37 Tire pressure
4-38 All tires have at least 5/32" of tread remaining
Check spare tire (tread/pressure)
Perform factory recommended maintenance if vehicle is within 2,500 miles of interval.
Wheels:
4-39 No damage
4-40 Install wheels and check for binding lug nuts (Hand-start all lug nuts and replace any that bind)
Check parking brake adjustment:
4-41 Properly adjusted
4-42 Verify Oil Quality As You Change Engine Oil and
Filter
4-43 Complete Applicable State Safety Emissions
Inspections
